RemiAustralianShepherd9months

  Mannerly Mutts E-Collar Usage Notes (Educator) Online full manual link to Educator Collar      Turning E-Collar on and off. Two red dots (one on collar and one on remote) are magnets.  This turns off (or on) the collar only. Line them up. Test with vibration button, which is the lone button on the side 2.  Turning the remote on and off                 a.  Large button on back turns off collar (small button changes mode so don't touch that).                 b.  Hold the large button down until you see the screen on the front come on (or go off if                           you are shutting it off for the evening. Charging E-Collar Daily. Turn collar off AND remote before putting it on charger. Charger used with collar and remote. Round hole covered by rubber in back or side (remote) is where it plus ...

Let's Go command.   So remember let's go means just move towards me.   You can tighten that up as much as you would like to be closer or farther away.   At the very beginning, I like them to come at least six feet from me. STEP 1:  Hold the long line appropriately through the handle STEP 2:  Begin walking your planned path until the dog is not following you anymore and has become distracted or not paying attention to what you are doing STEP 3:  At that point say "Let's Go" or "[Dog's Name] Let's Go" if you prefer. STEP 4A:  If the dog immediately comes towards you say "Good Boy" or "Good Let's Go".   STEP 4B:   If the dog doesn't (wait a couple of seconds to give them a chance, but not too long), use the top button (called the nick button) on the Dogtra collar and tap it repeatedly until the dog turns toward you, and then stop and encourage your dog forward STEP 4C:  If your dog gets confused or stuck wit...

Sit Reps with the Electronic collar: ***Some or all of these can be done in the above exercise, when the dog is called back to you.   Simply place them in a sit after a "let's go" or "come".   They can also be done as a stand alone. Equipment needed:    Electronic collar, flat or training collar for leash attachment, and long line or 6' leash. STEP 1:  . Make sure you have turned the electronic collar on correctly (use the vibrate button, which on the dogtra is the last button away from the antenna side).   Also make sure the collar was put on tight enough. STEP 2:   Come to a stop from whatever you are doing (walking with the dog or following the dog around).   Be sure that you have access to stepping on the long line fairly close to your dog.   In fact in the beginning, you may want to be stepping on it already. STEP 3:   Issue the command "sit". STEP 3A:   Give them a second.   If they sit within that time, be sure t...

PROPERTY OF MANNERLY MUTTS DOG TRAINING AND ROBIN RUBIN. WE ONLY ALLOW PAYING CLIENTS TO COPY THIS MATERIAL FOR THEIR USE ALONE. THIS MATERIAL MUST NOT BE DISTRIBUTED TO OTHER NON-CLIENT PARTIES OF MANNERLY MUTTS WITHOUT EXPRESS PERMISSION. NOTE ON STAYS:   DO NOT RUSH THROUGH THIS EXERCISE.   IF YOU STOP AT ONE SECTION, BUT DO THE BEST WORK POSSIBLE THAT IS MOST IMPORTANT.   IF YOU CAME HERE MORE ADVANCED, BUT HAVE TROUBLE AT ONE LEVEL, THEN BACK DOWN TO THE PREVIOUS LEVEL, AND GET THAT DONE CORRECTLY BEFORE MOVING ON.   CORRECTLY GOING ON MEANS THAT THE DOG CAN PERFORM THE TASK WITHOUT TREAT OR CORRECTION FOUR OUT OF FIVE TIMES. Equipment Needed: 6' Leash (to begin with) Training Collar (martingale, metal chain collar, or prong collar) 15' Leash (after four out of five stays while on the move with distractions can be accomplished at more than a 6' distance WITH distractions present) Explanation and Goal of Exercise:...